Circuit Crews

Washington electrical contractor specialties, explained

Every electrical contractor license in Washington is either a general license or a specialty license. The difference decides what work the firm may legally take on.

General or specialty

State law sets up two kinds of license. A general license gives the holder the right to do all electrical installation and maintenance work anywhere in the state. A specialty license gives a limited right: only the kinds of work named on the license. That split is in RCW 19.28.041, the statute that governs electrical contractor licenses.

In the state register for November 2026, most active licenses are general ones. The Washington page has the current count for each specialty.

The specialties you will see most

General (01)

No limit on the type of electrical work: houses, shops, factories, service upgrades, new builds.

Residential (02)

Wiring in homes and small multi-family buildings. A residential contractor is not licensed for a commercial fit-out.

Limited energy (06)

Low-voltage systems: alarms, data and phone cabling, audio, access control and similar. A limited energy contractor does not wire your panel or your outlets.

HVAC/refrigeration (06A)

Electrical work tied to heating, cooling and refrigeration equipment. Many heating firms hold this so they can connect the equipment they install.

Pump and irrigation (03), Signs (04), Maintenance (07)

Narrow scopes for well pumps and irrigation, electrical signs, and upkeep of existing systems. Each has sub-types, such as domestic pump (03A) and residential maintenance (07A).

Why it matters when you hire

The specialty is the quickest check that a firm is allowed to do your job. If you are adding a circuit or replacing a panel in a house, you want General or Residential. If a firm with a Limited energy license offers to do that work, it is outside what the license covers.

What every licensed contractor has in common

Whatever the specialty, the statute requires the contractor to file a $4,000 bond with the state and to name a person who holds a master electrician, administrator or matching specialty certificate. Licenses run for twenty-four months and then must be renewed.

Sources: RCW 19.28.041 (Washington State Legislature); Washington State Department of Labor & Industries contractor license data. The detailed scope of each specialty is set out in the department's electrical rules, WAC 296-46B.